ViPR SRM 3.x Storage Resource Management Exam v6.0
Question 1
In addition to validation of discovered storage infrastructure against design best practices and the EMC Support Matrix for compliance, what features does the Storage Compliance
SolutionPack provide?
- A. Generates compliance breach reports and automated breach alert notifications
- B. Generates compliance breach reports, automated breach alert notifications and what if change modeling
- C. Validation against regulatory policies for compliance, generates compliance breach reports, and automated breach alert notifications
- D. Validation of the discovered storage infrastructure against regulatory policies for compliance, generates compliance breach reports, automated breach alert notifications, and what if change modeling
Answer : A
Question 2
Which Frontend module runs the task used to avoid repeated and potentially unnecessary queries to the databases?
- A. APG-Property-Store
- B. APG-Diagnostic-Tools
- C. APG-Frontend
- D. APG-Self_Monitoring_Collector
Answer : A
Question 3
Which default port does the Centralized Management Module use to communicate remote commands to the WebService Gateway?
- A. 48443
- B. 58080
- C. 443
- D. 8443
Answer : A
Question 4
When installing a SolutionPack, the installer places the Reports on the host where the
Frontend runs using which service?
- A. Webservice-Gateway
- B. Task-Scheduler
- C. Collector-Manager
- D. APG-Property-Store
Answer : A
Question 5
In a VMAX discovery, what metric is available through the SMI-S Provider?
- A. LUN write request
- B. Array FE Directors - %busy
- C. Disk I/O Rate
- D. RDF Director Write Throughput
Answer : A
Question 6
When you deploy the Physical Host SolutionPack on a Windows host, what needs to be considered about the way it will leverage the Generic-RSC collector-manager?
- A. The collector-manager can collect data on both Windows and Linux hosts
- B. The collector-manager can only collect data on other Windows hosts
- C. The collector-manager is agentless and does not require scripts
- D. The collector-manager can use either port 5985 or 5986 to access the Linux and Windows hosts
Answer : A
Question 7
What determines if a CLARiiON array can be discovered by ViPR SRM?
- A. Any array with FLARE 30 and later
- B. Any array with FLARE 29 and later
- C. Any array with FLARE 26 and later
- D. All CLARiiON arrays are supported
Answer : A
Question 8
When deploying the VMAX SolutionPack with a Remote Solutions Enabler what must be entered exactly as it appears in the netcnfg file?
- A. SYMAPI Connection Name
- B. Hostname of the Collector Host
- C. IP Address of the Backend Host
- D. Solutions Enabler bin directory path
Answer : A
Question 9
Which statement is true regarding the EMC Host Interface SolutionPack?
- A. EMC Host Interface agent software must be installed on hosts to be discovered and enables collection of data from hosts without requiring host credentials.
- B. EMC Host Interface SolutionPack enables agentless host discovery by interfacing with hosts across the IP network.
- C. EMC Host Interface agent software must be installed on hosts to be discovered and enables collection of data from hosts using host credentials.
- D. Installation of the EMC Host Interface SolutionPack deploys many built-in host reports and requires the Host Interface agent software to be installed on hosts to be discovered.
Answer : A
Question 10
Refer to the exhibit.
The array summary, Raw Capacity Usage bar graph shows Unusable and Unconfigured capacity much higher than the configured capacity. What does this indicate?
A. The licensed storage capacity is much lower than the physical storage capacity. This could be a result of short-stroke drive configuration.
B. The licensed storage capacity has been incorrectly applied.
C. The array storage configuration has a misconfigured disk drive setting.
D. The storage manager has decided to only configure a lower percentage of the total storage.
Answer : A Topic 3, ViPR SRM Implementation and Maintenance
Question 11
Which utility should be used to do advanced troubleshooting of data collection?
- A. File-Connector
- B. Manage-modules.sh
- C. Search Engine
- D. MySQL
Answer : A
Question 12
What is the real outcome of data enrichment?
- A. Complements data sets so that reports can be customized
- B. Tags data according to preset thresholds for reports
- C. Helps database to better index data sets
- D. Optimizes data collection (cache buffer)
Answer : A
Question 13
In the context of reporting, what are some common ViPR SRM properties conventions?
- A. Devtype, device, parttype, part, name
- B. All properties set for a given metric
- C. Timestamp, variable id, value, and properties
- D. Real-time, 1-hour, 1-day, 1-week aggregates
Answer : A
Question 14
Two Brocade switches are discovered in a ViPR SRM instance. Even though the Enable
Passive Host Discovery checkbox had been selected in the Brocade FC Switch
SolutionPack configuration, there are no hosts under the Passively Discovered Hosts folder. What could be the cause of this issue?
- A. Invalid SMI-S credentials
- B. SNMP Port blocked by a firewall
- C. Incorrect SNMP community string
- D. Default zoning is enabled on the switches
Answer : A
Question 15
What comparison types can be used to evaluate key property values?
- A. String, regex, wildcard, and range
- B. String, regex, wildcard, and numeric
- C. Regex, wildcard, range, and numeric
- D. Regex, wildcard, range, and literal
Answer : A