An implementation engineer is at a customer site to install a Dell PowerProtect Data Domain appliance. Which two initial actions that must be performed? (Choose two.)
Answer : AB
Which three cloud tiering data-movement policies are supported on a Dell PowerProtect Data Domain appliance? (Choose three.)
Answer : BCD
A customer has asked the implementation engineer to review the dashboard with them to understand the information provided about the Dell PowerProtect Data Domain appliance.
Which three sections can be seen in the Dell PowerProtect Data Domain System Manager dashboard? (Choose three.)
Answer : BCD
A technician is installing a PowerProtect DD6410 system with two ES120 expansion shelves.
Which two installation guidelines must be followed to ensure proper setup? (Choose two.)
Answer : AB
An implementation engineer must enable immutable backup protection on a Dell PowerProtected Data Domain MTree.
What is the first step in performing this task?
Answer : A
During testing, a Dell PowerProtect Data Domain appliance is experiencing a bottleneck during high-concurrency backups. The configuration uses a single physical 10GbE interface for DD Boost. The implementation engineer decides to create a DD Boost Interface Group containing four physical interfaces.
What is a primary structural requirement for this specific connectivity setup to function?
Answer : D
Which two steps must be performed to configure the iDRAC on a Dell PowerProtect DD9910 during the boot process? (Choose two.)
Answer : BC
An implementation engineer is configuring a Dell PowerProtect Data Domain appliance that will be used to store Avamar backups. The network consists of two 1 GB/s and four 10 GB/s network connections. They want to ensure that backup traffic uses only the four 10 GB/s connections.
What should be done in Dell PowerProtect Data Domain Operating System to meet this goal?
Answer : B
An implementation engineer is trying to generate the support bundle for a physical Dell PowerProtect Data Domain Appliance with a DIMM failure. The iDRAC logs out every 20 seconds and the engineer is unable to finish the Technical Support Report (TSR) download from the iIDRAC.
What two steps are part of an alternate recommended process to capture a hardware report? (Choose two.)
Answer : AB When the iDRAC interface is unusable, the engineer can boot into Lifecycle Controller, generate the hardware/technical support report, and export it to a connected USB drive. BIOS does not provide the report-export workflow.
Security policies require all Dell PowerProtect Data Domain appliance’s log messages to be ingested by a central Security Information and Event Management (SIEM) system right after go-live.
Which task is done to configure this?
Answer : B
An implementation engineer is using a Dell PowerProtect DD9910 appliance to host Virtual Tape Library (VTL) backups. To limit the capacity used by the tape pool, only 100 tapes will be allowed in the barcode range.
Which barcodes satisfies this requirement?
Answer : A
An implementation engineer is deploying a Dell PowerProtect DD9910F with two FS240 disk enclosures.
Which rule must be followed when cabling the disk enclosures?
Answer : B
An implementation engineer is setting up DDBoost with IFGroups on a Dell PowerProtect Data Domain appliance for both IPv4 and IPv6.
What must be done when configuring the DD Bost IFGroups?
Answer : B
For Dell PowerProtect Data Domain appliances, how is the Service Tag formatted?
Answer : D
How many rack units are required for an implementation consisting of a DD6410 controller with three ES120 expansion trays?
Answer : A
Have any questions or issues ? Please dont hesitate to contact us