Which storage policy action results in a component resync?
Answer : D
vSAN is configured with a storage policy with a Failures To Tolerate (FTT) set to three.
Which type of redundancy is being used?
Answer : B
Reference:
https://www.sbarjatiya.com/notes_wiki/index.php/About_VSAN_6.6
Which default VMware vSphere High Availability cluster setting must be changed when using a vSAN stretched cluster?
Answer : D
Reference:
https://docs.vmware.com/en/VMware-vSphere/6.5/com.vmware.vsphere.virtualsan.doc/GUID-D68890D8-841A-4BD1-ACA1-DA3D25B6A37A.html
The cluster level backend IOPS performance graph shows a higher-than-average number of IOPS.
What is a possible reason for this?
Answer : A
Reference:
https://kb.vmware.com/s/article/2144493
An administrator of a vSAN 6.5 environment is planning a path to move to unicast for the vSAN network.
How will the administrator achieve this?
Answer : B
When using vSAN Encryption, where does the Key Encryption Key persistently reside?
Answer : C
Reference:
https://blogs.vmware.com/virtualblocks/2018/07/13/understanding-ve-booting-w-vc-unavailable/
What is a mandatory requirement for a vSAN stretched cluster?
Answer : D
Reference:
https://vsan-essentials.gitbooks.io/vsan-6-2/content/chapter8.html
An architect is asked to design a vSAN cluster with these requirements:
-Supports erasure coding storage policy
-Minimized inaccessibility from single device failures
-Ability to re-protect data after a failure
The desired configuration should be able to survive a single failure.
Which configuration satisfies the design requirements?
Answer : D
A new vSAN cluster needs to run 900 VMs and protect against one failure.
What is the minimum number of nodes needed to meet the requirement?
Answer : A
Refer to the exhibit.
Answer : A
Which two factors should be considered when planning usable vSAN datastore capacity? (Choose two.)
Answer : BE
Reference:
https://docs.vmware.com/en/VMware-vSphere/6.7/vsan-671-planning-deployment-guide.pdf
(23)
An ESXi host is being re-purposed from a 4-node cluster. The default policy is in use and storage utilization is low.
Which maintenance mode should be used to avoid storage policy non-compliance?
Answer : A
Reference:
https://storagehub.vmware.com/t/vmware-vsan/vsan-2-node-guide/maintenance-mode-consideration-9/
What would cause a vSAN: Basic (unicast) connectivity check failure in vSAN Health Check?
Answer : A
Reference:
https://communities.vmware.com/thread/576629
What is the maximum number of failures an object can tolerate with RAID-6?
Answer : A
Reference:
https://vsan-essentials.gitbooks.io/vsan-6-2/content/chapter6.html
What is a supported use of the vSAN iSCSI target service?
Answer : D
Reference:
https://docs.vmware.com/en/VMware-vSphere/6.7/com.vmware.vsphere.virtualsan.doc/GUID-13ADF2FC-9664-448B-A9F3-31059E8FC80E.html
Have any questions or issues ? Please dont hesitate to contact us