Check Point Certified Maestro Expert v1.0

Page:    1 / 3   
Exam contains 46 questions

What is the basic installation sequence of the Orchestrator in case of single Orchestrator?
1. Create a Security Group
2. Configure Default Gateway
3. Connect with Serial Console cable to the Orchestrator
4. Configure IP for one of its Management interfaces
5. Connect an appliance to a downlink port
6. Change Orchestrator amount to 1
7. Browse to the Orchestrator’s WebUI

  • A. 3-4-2-6-5-7-1
  • B. 3-1-7-2-4-6-5
  • C. 1-4-2-5-7-3-6
  • D. 7-4-2-5-3-1-6


Answer : A

Which command will be used in order to restart Orchestrator service only?

  • A. orchd restart
  • B. cpstop; cpstart
  • C. reboot
  • D. service orchestrator restart


Answer : D

Orchestrator should be defined in SmartConsole as:

  • A. Orchestrator is not defined in SmartConsole
  • B. Check Point host
  • C. Security Gateway
  • D. Host


Answer : A

How many power supplies are presented on MHO-140?

  • A. 2
  • B. 4
  • C. 1
  • D. 1 with option for 2


Answer : A

What is the maximum amount of Appliances within Security group in Dual-Site configuration?

  • A. 16
  • B. 15
  • C. 28
  • D. 31


Answer : C

What is the default range of physical ports for downlinks on Orchestrator MHO-140?

  • A. 25 - 47
  • B. 27 - 47
  • C. 1 - 48
  • D. 1 - 25


Answer : B

What kinds of transceivers are supported on Orchestrator MHO-140?

  • A. SFP, QSFP, QSFP28
  • B. SFP, SFP+, QSFP, QSFP28
  • C. SFP, SFP+, SFP28
  • D. SFP+, SFP28, QSFP


Answer : B

What is the Orchestrator?

  • A. Load balancer
  • B. Network Switch
  • C. Manager of compute and network resources, load balancer and network switch
  • D. None of above


Answer : D

What is the Iterator process?

  • A. Iterator is the process that simulates distribution in case of Appliance failure
  • B. Iterator is the process that follow Appliance recovery and simulates what was a distribution if recovered Appliance was alive
  • C. Iterator is the process that runs on the Orchestrator and calculates a distribution in case of Appliance failure
  • D. Iterator is the process that runs on the Orchestrator and calculates a distribution in case of Appliance recovery


Answer : C

What is the throughput penalty of Security Group?

  • A. 5% per member
  • B. Depends on the type of Appliance
  • C. 10% per Security Group with no relation to amount of members
  • D. 1% per member


Answer : В

Which is a valid requirement for a supported Maestro appliance?

  • A. 10GBps and 40Gbps or 100Gbps card with double-VLAN and LLDP support
  • B. At least one 10GBps line card
  • C. Nothing special as Maestro supports any Check Point appliance
  • D. Line card with double-VLAN and LLDP support


Answer : A

Which setting is required in order to connect an appliance with 40Gbps downlink interface and DAC to the Orchestrator MHO-140?

  • A. On Orchestrator: Change QSFP mode from 100Gbps to 40Gbps
  • B. On Orchestrator: Change port type from uplink to downlink
  • C. On Appliance: Change a port speed to 10Gbps
  • D. No change required


Answer : B

What does the lldpctl command do?

  • A. Show all devices discovered by LLDP protocol on downlink ports
  • B. Discover orchestrators
  • C. Show all devices discovered by LLDP protocol on uplink ports
  • D. Show all devices discovered by LLDP protocol on all ports


Answer : D

In case of VSX: What is the right command to see overall performance details of all Appliances within the Security Group and all Virtual Systems?

  • A. asg pert -v -p
  • B. asg pert -vs all -v -vv
  • C. asg pert -v
  • D. asg pert -vs enabled -p


Answer : B

When running asg perf -v in a Dual-Site environment, we can see only Appliances from one of the sites. That means we’re working in:

  • A. VSLS mode
  • B. Active /Active
  • C. Active / Standby HA mode
  • D. This is not Dual-Site, in Dual-Site we always see Appliances from both sites


Answer : C

Page:    1 / 3   
Exam contains 46 questions

Talk to us!


Have any questions or issues ? Please dont hesitate to contact us

Certlibrary.com is owned by MBS Tech Limited: Room 1905 Nam Wo Hong Building, 148 Wing Lok Street, Sheung Wan, Hong Kong. Company registration number: 2310926
Certlibrary doesn't offer Real Microsoft Exam Questions. Certlibrary Materials do not contain actual questions and answers from Cisco's Certification Exams.
CFA Institute does not endorse, promote or warrant the accuracy or quality of Certlibrary. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Terms & Conditions | Privacy Policy